Happy NY folks, let's hope its better than 2016.
Just wondered whether anyone has a recommendation for chamfering/deburring small holes in steel/ti? Got some messy 2mm holes to clean up.
Also, just been practising flat grinds all over xmas (waiting for the large wheel etc to start hollow grinding) and have gradually stopped shaping out a full profile (i.e. incl. handle) for each blade and have instead cut a blank just behind where the pivot would be and use the (approx location) pivot hole to fasten on to the jig. Obviously with a full knife and handle/tang you're good for fixing to a jig but for a folder blade, what are people doing, just fixing by the pivot hole (not great for an eventual precision fit I'd have thought) or leaving an extra section behind to later remove when the grind is complete?